Electricians in Crewe, Cheshire

Electrical fault finding in Crewe: find out why it keeps tripping

A switch that trips at random, a socket that has stopped working, lights that flicker when the washer spins. Say what happens and when, and a local electrician will call you back.

Ask a Crewe electrician for a quote

Four short boxes. A minute at most.

By sending this form you agree to your details being shared with a local electrician so they can contact you. See our privacy notice.

  • The cause found and shown to you, with no guesswork
  • Faults that come and go tracked down by testing
  • Burnt sockets, worn switches and damaged cable replaced
  • Free to ask, with typical hourly figures on this page

It trips, you reset it, it trips again

At first it was once a month. Now it is most evenings. You have learned which switch to push and you can do it in the dark.

You have tried to find a pattern. Is it the dishwasher? The rain? The outside light? Every time you think you have it, the power goes off when none of those is running.

Meanwhile the oven clock flashes midnight, the broadband box restarts and the freezer warms up a little more each time. A fault you cannot see is slowly wearing your patience down.

How it works, start to finish

  1. Describe the fault or the job

    Type your name, phone number and area, then say what is happening in plain words. Which switch trips, which room, how long it has gone on. If it cannot wait, set the urgent switch to yes.

  2. A local electrician phones you

    An electrician who works around Crewe calls at the time you chose. Expect a few questions about the house and the fuse box. Many jobs need a short visit before a firm figure can be given.

  3. You choose what happens next

    You are given a price for the work. Have it put in writing, think it over, and say yes only if it suits you. Sending the form costs nothing and ties you to nothing.

What usually lies behind a fault

  • A failing appliance. A kettle, washing machine or oven element near the end of its life leaks a little current, and the fuse box notices.
  • Damp. Rain gets into an outside light, a garden socket or a cable that passes through a wall.
  • A damaged cable. A nail from a picture, a screw through a floorboard, or a cable crushed during other building work.
  • A tired connection. A terminal that has worked loose in a socket or junction box heats up, cools down and slowly burns.
  • Too much on one circuit. A kitchen full of modern appliances on wiring planned for a kettle and a toaster.
  • Old cable. Insulation that has gone brittle with age lets current stray where it should not.

Our guide to why a fuse box keeps tripping explains each of these in more depth, and what the different switches on the board are telling you.

How an electrician tracks it down

Fault finding follows a method. The electrician begins with your account of what happens, then turns the power off and tests each circuit with a meter. The tests measure how sound the insulation is on every cable and how good each connection is.

A circuit that fails the test is then split in half and each half is tested again. Then that half is halved. Step by step the search narrows to one length of cable, one socket or one fitting. It is patient work, and it is the only way to be sure.

Faults that come and go are the hardest. A cable that only leaks when the wall is wet will test clean on a dry afternoon. This is where your notes matter. The time of day, the weather and what was switched on can save an hour of searching.

What to jot down before the call

  • Which switch in the fuse box trips, counting from the left
  • What time of day it tends to happen
  • What was running: shower, oven, washer, heating
  • If it is worse in wet weather
  • Any building work, new appliance or leak in the last few months
  • Roughly how old the fuse box looks

That is all you need to do. Leave the testing to the electrician, and never take the cover off anything to look for the fault yourself.

What fault finding costs

No one can price a fault before it has been found, so this work is charged by the hour. The repair, once the cause is known, is usually a fixed sum.

JobUK guide price
An electrician's time, each hourSource: Checkatrade electrician hourly rate guide£40 to £70typical about £55
Electrical safety check of the whole house (EICR)Source: Checkatrade electrical safety check cost guide£100 to £250typical about £200

Typical UK guide prices from the Checkatrade guides named, shown before VAT. Take them as guides, never as quotes. The hourly guide says a minimum call-out charge often covers travel, the first hour and basic fault finding.

Faults in Crewe's older houses

Much of Crewe was built by the railway in the 1800s, long before homes had electricity. In a terrace of that age the wiring has been added to many times. A circuit may begin in modern grey cable at the fuse box and end in something far older under the back bedroom floor.

That makes fault finding slower than in a new house, because no two circuits follow the plan you would expect. It also means one fault is sometimes a sign of wider wear. If several circuits test poorly, the electrician may suggest a full safety check so you can see the state of the whole house on one report.

Where the board itself is the weak point, a new fuse box can be the right cure. And if something is hot, smoking or sparking, do not wait: go to the emergency electrician page.

Electrical services in Crewe

Crewe and the places around it

An electrician for the whole of Crewe and for these villages and towns nearby.

  • Crewe town centre and Nantwich Road
  • Coppenhall
  • Hightown
  • Leighton and Barrows Green
  • Woolstanwood and Rope
  • Wistaston
  • Willaston
  • Shavington
  • Wybunbury
  • Weston
  • Crewe Green
  • Haslington and Winterley
  • Nantwich
  • Sandbach
  • Alsager

See all the areas around Crewe

Four things worth knowing

  • Nothing to pay and no one to answer to. There is no fee for sending the form. You are never obliged to accept a price, and you can walk away at any stage.
  • Only four boxes to fill. You give a name, a number, your area and the fault. No email address, no street address, no account to set up.
  • Prices here are sourced, not made up. Each figure on this site is a typical UK guide price read from a published cost guide, with the guide named and linked beside it. Your own home will need its own quote.
  • Your details are used for this job only. They go towards getting your electrics sorted. Nobody sells them on, and you will not get marketing because of them.

Common questions

Why do my electrics trip when it rains?

Water is getting in somewhere. The usual suspects are an outside light, a garden socket, a cable to a shed, or a cable that runs through a damp wall. Switch that circuit off at the fuse box if you know which it is, and ask an electrician to test it.

Can one faulty appliance trip the whole house?

Yes. On many fuse boxes one safety switch protects several circuits at once, so a fault on a single appliance can take out half the house or all of it. If the tripping stops when a certain appliance is left unplugged, tell the electrician. It is a strong clue.

How long does it take to find a fault?

A fault that is present all the time can often be found on the first visit. One that comes and goes can take longer, because it has to be caught while it is happening. Good notes from you shorten the search.

Stop resetting it and get it found

Each time a switch trips, it is cutting off a fault that could give a shock or start a fire. Pushing it back up does not remove the fault. Damp spreads, loose connections burn a little more, and brittle cable does not get younger. A fault found early is nearly always a smaller repair.

Say which switch trips and when, and name your part of Crewe. You are not charged for sending the form.

Ask a Crewe electrician for a quote

Four short boxes. A minute at most.

By sending this form you agree to your details being shared with a local electrician so they can contact you. See our privacy notice.

Get a free quote